Frequently Asked Questions

Back To All Faqs

iTaste MVP

MVP - Charging





To charge the MVP battery first turn the switch on the base of the unit to the OFF position (it should normally be in the OFF position anyway). Then connect the smallest end of the charging lead (micro USB plug) into the port marked "input" on the base of the MVP.





The other end of the charging lead (standard USB) connects to a USB charging port. The USB charging port can be found on a mains adapter (see below), or a USB port on a personal computer.
Important: Always use the correct charger. NEVER use an iPhone or other charger - they may output too much current and cause batteries to overheat or explode


USB charging ports as seen on UK and Euro mains adapters



When the battery is plugged into a charing source, the LED light within the switch will flash a number of times and then show either red (empty/almost empty), orange (some charge remains) or green (good state of charge).

Important:
1) To fully charge the battery continue charging until the LED light goes completely off. Only then is the battery fully charged.

2) To use the unit whilst charging, it needs to be in either an orange or green state.


The battery should charge from flat to full in approximately 5 hours. If the battery is partially charged already, of course this time will be reduced.