Frequently Asked Questions

iClear16 Dual Coil XL Clearomiser

iClear16 Dual Coil XL Clearomiser - Filling

These are the steps to fill the iClear16 Dual Coil XL Clearomiser;

1) First remove the iClear from your device and then remove the mouthpiece by unscrewing in an anti-clockwise direction. Take care to always grip by the metal banding and not by the clear tube as this may cause breakages.

Take Care: Continue to use a screwing motion, even when the thread has disengaged. This will help prevent the internal seal from being dislodged. Observe seals and remove any dirt, hairs or other debris.
2) Next hold the body at an angle and squeeze in the juice, avoiding the centre hole/tube. Avoid overfilling, filling up to the 1.6ml mark if required.

3) Replace the mouthpiece (taking care as described in point 1 and also below) and then the final step is to place a piece of tissue paper over the threaded end and give a sharp blow through from the mouthpiece end. This removes any liquid that may have managed to accumulate in the centre hole as you do not want this to get into your device.

Take Care with threads: When bringing items together that have threads - back them up in reverse direction until they engage properly, before turning in correct direction to tighten. This will reduce the possibility of cross threading.

Important Note: If this is the first time you are filling your Clearo - wait a few minutes for the juice to soak up and prime the coil. Make a cup of tea or coffee, perhaps something a little stronger, or just chill - but give it a few minutes before using it. We know it's hard, but resist the temptation and your patience will be rewarded :) If you don't do this, you may experience some 'dry hits'.

That's it, your iClear16 Dual Coil XL Clearomiser is filled and ready for use. Please note that you may need to wait a few minutes for the liquid to soak into the wicks and reach the coils