Frequently Asked Questions

Back To All Faqs

Kanger Evod

Kanger Evod - Filling

These are the steps to fill the Kanger Evod Clearos;

1) Simply remove the Tank from your device and then turn upside and unscrew the base piece in an anti-clockwise direction.

2) This reveals the filling area. Add liquid avoiding the centre tube/airhole and being careful not to overfill.

3) After filling, replace the base piece complete with atomiser head (attached to base already) and then use a tissue to clean up any excess liquid.

4) The final step is to place a piece of tissue paper over the base piece end and give a sharp blow through from the mouthpiece end. This removes any liquid that may have managed to accumulate in the centre hole as you do not want this to get into your device, or back into your mouth.

Take Care with threads: When bringing items together that have threads - back them up in reverse direction until they engage properly, before turning in correct direction to tighten. This will reduce the possibility of cross threading.

Important Note: If this is the first time you are filling your tank - wait a few minutes for the juice to soak up and prime the coil. Make a cup of tea or coffee, perhaps something a little stronger, or just chill - but give it a few minutes before using it. We know it's hard, but resist the temptation and your patience will be rewarded :) If you don't do this, you may experience some 'dry hits'.